New Carbon Materials•2026•DOI: 10.1016/S1872-5805(25)61036-5
Large graphene oxide (LGO) sheets offer significant advantages over smaller ones in various applications, yet their production via Hummers-type oxidation of large natural graphite flakes remains challenging due to difficulties in achieving full oxidation and avoiding fragmentation. This study provides the first direct evidence that large graphite flakes (up to 1 mm) can be completely oxidized without fragmentation under static conditions, as revealed by in-situ monitoring. The oxidation process is governed by diffusion of the oxidizer between layers, described by Fick's law, where a high oxidizer concentration gradient increases the diffusion rate. By minimizing the amount of concentrated H2SO4 solvent, we achieved a semi-solid state that elevates oxidizer concentration, facilitating Mn(VII) diffusion and enabling complete oxidation of gram-scale large flakes with significantly reduced reagent consumption. Reaction temperature was optimized to balance graphite oxidation and Mn(VII) self-decomposition. Using this approach, 200-, 100-, and 50-mesh natural graphite were fully oxidized with reduced H2SO4 and KMnO4 usage. After exfoliation, LGO with average lateral sizes of 27.3, 58.7, and 116.2 μm were obtained, respectively, with 100% conversion and yield over 165%. This work not only provides a scalable, cost-effective strategy for LGO production but also advances the fundamental understanding of Hummers-type oxidation.
Journal of Fuel Chemistry and Technology•2026•DOI: 10.3724/2097-213X.2025.JFCT.0026
The catalytic hydrogenation of carbon dioxide (CO2) to light olefins (C2–C4) represents a pivotal route for mitigating greenhouse gas emissions while producing high-value chemical feedstocks. This review systematically examines the two principal technological pathways: CO2-Fischer-Tropsch synthesis (CO2-FTO) and CO2-methanol-to-olefins (CO2-MTO). The CO2-FTO route couples reverse water-gas shift (RWGS) with Fischer-Tropsch synthesis, whereas CO2-MTO proceeds via methanol intermediate. Key challenges arise from the thermodynamic stability of CO2 (C=O bond dissociation energy ~750 kJ/mol) and kinetic limitations. The review critically evaluates the influence of catalyst promoters (e.g., Na, Mn, Cu), support structures, and surface defect site concentrations on CO2 activation and olefin selectivity. For zeolite-based catalysts, pore architecture and acidity are shown to govern methanol conversion to olefins. Representative data from the literature indicate that Fe-based catalysts with Na promotion achieve CO2 conversion up to 40% with olefin selectivity exceeding 50% under optimized conditions. The review underscores the necessity of integrating catalyst design with reactor engineering to overcome thermodynamic constraints and achieve industrially viable performance.
Journal of Environmental Engineering Technology•2026•DOI: 10.13205/j.hjgc.202604017
The Shule River Basin, a typical arid inland river basin, faces critical water scarcity that threatens ecological security and sustainable development. This study integrated the FLUS and InVEST models to simulate water yield in 2030 and 2050 under three climate scenarios (SSP119, SSP245, SSP585). Geographic detectors quantified the driving mechanisms of natural and human factors. Results showed: (1) Desert dominates land use (78.6% in 2020). Under SSP119, desert area decreases by 0.69% by 2050, while under SSP585 it expands by 5.7%, with grassland loss of 23.0%, indicating severe ecological degradation. (2) Water yield exhibits a south-high, north-low spatial pattern, with high values in glacier-covered and high-altitude areas. SSP119 yields the most significant increase (147.6×10^8 t by 2050), whereas SSP585 shows minimal increase (43.9×10^8 t) due to extreme climate. (3) Precipitation and DEM are core driving factors; the interaction between land use type and precipitation has the strongest influence, implying that artificial land use changes can significantly regulate water yield. This multi-scenario framework provides decision support for water resource management and ecological governance in arid inland river basins.
SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-025-3768-8
Damping materials are critical for mitigating vibrations and noise across various frequencies by converting mechanical energy into thermal energy. However, achieving a simultaneous high damping capacity and high toughness remains a formidable challenge. Here, we report a supramolecular polymer (SMP) that integrates high damping and toughness through the synergistic action of dynamic hydrogen bonds and side-chain relaxation. The polymer exhibits exceptional mechanical properties: a Young's modulus of 47.08 MPa, elongation at break of 605%, and toughness of 15.24 MJ m−3. The dynamic hydrogen bonds confer dual responsiveness to strain rate and temperature, with a 6.7-fold variation in Young's modulus under different stretching rates and a five-order-of-magnitude change in storage modulus across a temperature range. Under mechanical force, the interpenetrating side chains undergo mutual friction, enabling repetitive energy dissipation. This mechanism yields superior damping ability with a loss factor (tanδ) of 1.6 at 1 Hz, demonstrating outstanding performance in vibration absorption and noise reduction. The material's design offers a promising strategy for developing high-performance damping materials that balance energy dissipation and mechanical robustness, suitable for applications in wearable electronics, protective equipment, and structural vibration control.
Journal of Fuel Chemistry and Technology•2026•DOI: 10.3724/2097-213X.2025.JFCT.0036
Liquefied petroleum gas (LPG) is a clean fuel and essential chemical feedstock. This review summarizes recent advances in the hydrogenation of CO and CO2 (COx) to LPG, focusing on the design and optimization of bifunctional catalysts. The adsorption and activation of COx on various metal oxide surfaces, as well as the influence of zeolite pore structure and acidity on LPG selectivity, are critically evaluated. The synergistic effects between metal oxide and zeolite components in promoting LPG production and enhancing catalyst stability are elucidated. Key catalyst systems, including GaZrOx/H-SSZ-13 and InZrOx-Beta composites, demonstrate high selectivity to propane and isobutane-enriched C4 alkanes, respectively. The review highlights the importance of balancing methanol synthesis and hydrocarbon conversion functionalities to achieve high LPG yields while suppressing undesired methane and CO formation. Challenges such as catalyst deactivation and the need for precise control of acid site density are discussed. This work provides theoretical guidance for the rational design of highly efficient catalytic systems for COx hydrogenation to LPG, contributing to carbon resource utilization and emission reduction.
Journal of Environmental Engineering Technology•2026•DOI: 10.13205/j.hjgc.202606018
Swine wastewater, a high-strength organic effluent, offers a viable substrate for anaerobic biohydrogen production, aligning with clean energy recovery. This study compared hydrogen production in three anaerobic sequencing batch reactors (ASBRs) treating: raw wastewater (R1), supernatant after MAP (magnesium ammonium phosphate) precipitation for nitrogen and phosphorus recovery (R2), and the same supernatant with anaerobic sludge heat-treated at 75°C for 0.5 h (R3). Without pH adjustment, hydrogen production in R1 remained below 0.50 mmol/(kg·d). At an influent COD of 1800 mg/L, R2 and R3 achieved hydrogen production rates of 48.17 and 71.44 mmol/(kg·d), respectively. At COD 2400 mg/L, methane concentrations in R1, R2, and R3 were 10.8%, 14.2%, and 9.1%, respectively, indicating MAP pretreatment enhanced both hydrogen and methane production. As COD increased, R1's methane concentration rose to 14.6%, while average COD removal efficiencies for R1, R2, and R3 were 78.9%, 70.8%, and 52.5%, respectively. Under pH adjustment, all reactors peaked at pH 4.0, with hydrogen production rates of 0.10, 7.74, and 8.83 mol/(kg·d) for R1, R2, and R3, respectively. These findings demonstrate that MAP pretreatment combined with sludge heat treatment significantly enhances biohydrogen production, offering a promising strategy for swine wastewater valorization.
Environmental Chemistry•2026•DOI: 10.7524/j.issn.0254-6108.2025032401
Diazepam (DZP), a benzodiazepine anxiolytic drug, has been a persistent contaminant in fishery water environments. In China, DZP is classified as a veterinary drug that must not be detected in animal-derived foods, yet it is frequently found in aquatic products, posing significant risks to ecological health and food safety. This review systematically summarizes the current pollution status of DZP in fishery water and its adverse effects on aquatic organisms, emphasizing its persistence in both water and aquatic products. The paper comprehensively examines advances in detection techniques, including gas chromatography-mass spectrometry (GC-MS) and liquid chromatography-tandem mass spectrometry (LC-MS/MS), as well as treatment technologies such as adsorption, photolysis, chemical oxidation, and biodegradation. Critical gaps remain in the integration of these technologies for practical remediation. The review underscores the urgent need for enhanced monitoring and risk assessment of DZP contamination, alongside the development of more efficient and scalable treatment methods. By consolidating current knowledge, this work provides technical support for aquatic organism protection and fishery water management, and serves as a reference for future research and technological innovation in this field.
Chinese Journal of Environmental Engineering•2026•DOI: 10.12030/j.cjee.202511054
A novel S-scheme heterojunction photocatalyst, Bi6O5(OH)3(NO3)5·3H2O/BiOBr0.8I0.2 (BON@BI), was synthesized via a one-step hydrothermal method using Bi6O5(OH)3(NO3)5·3H2O (BON), KBr, and KI as precursors. The mass ratio of BON to BiOBr0.8I0.2 (BI) was optimized, revealing that the 20% BON@BI composite (BON@BIOPT) exhibited the highest visible-light photocatalytic activity. Under 30 min of visible-light irradiation, BON@BIOPT achieved a 99.8% degradation efficiency of Rhodamine B (RhB), approximately twice that of pristine BI (52.2%). The composite displayed a rod-like morphology with uniform nanosheets, and its specific surface area increased from 32.54 m²·g⁻¹ (BI) to 44.7 m²·g⁻¹. The absorption edge red-shifted from 560 nm (BI) to 580 nm, narrowing the bandgap from 2.55 eV to 2.43 eV. The S-scheme heterojunction formed between BON and BI generates an internal electric field that effectively suppresses recombination of strongly reducing photogenerated electrons and strongly oxidizing holes, with superoxide radicals (O₂•⁻) and holes (h⁺) identified as the primary reactive species. BON@BIOPT exhibited excellent stability, retaining 88.6% degradation efficiency after seven consecutive cycles. It also demonstrated robust environmental adaptability, maintaining 85–98% degradation efficiency under various pH conditions and in the presence of interfering anions. The degradation pathway of RhB involves N-de-ethylation, cleavage of the conjugated chromophore, and deamination, ultimately mineralizing into low-molecular-weight organics, inorganic salts, CO₂, and H₂O. These results underscore the potential of BON@BIOPT for practical remediation of organic pollutants in water.