SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-025-3799-4
Li-rich layered oxides (LLOs) xLi2MnO3·(1−x)LiTMO2 (0 < x < 1, TM = Mn, Ni, Co, etc.) are promising high-energy cathode materials for lithium-ion batteries, capable of achieving energy densities up to 1000 Wh kg−1. However, their practical application is hindered by limited cycle life and voltage decay, primarily stemming from structural instability of Li2MnO3 and LiTMO2 domains during cycling, which manifests as transition metal cation migration, oxygen release, and TM dissolution. This review establishes a comprehensive design and modification scheme based on the fundamental structural unit of LLOs: the LiMn6 hexatomic-ring. In this unit, each Li atom in the TM layer is surrounded by six Mn atoms, forming a π-type hybridization between Mn 3d(t2g) and O 2p orbitals, creating an intact π-bond ring that acts as a distributed redox center. Ordering these functional units into specific spatial configurations can enhance capacity, voltage, and structural stability. However, substituting Mn with other elements breaks the symmetry of the π-bond ring, altering redox behavior and reversibility. The spatial arrangement of LiMn6 rings, representing the arrangement of π-bond rings, is critical for redox activity. In Li2MnO3, the typical honeycomb superstructure of LiMn6 rings is discussed. This review highlights the importance of functional unit ordering in material design, drawing parallels from other systems, and proposes a systematic approach to engineer LLOs for improved electrochemical performance.
SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-026-4148-3
Biological ion channels exhibit multistate transport behavior beyond simple binary open-closed conformations, enabling dynamic control of neural signaling and transmembrane substance transport. Inspired by this, we synthesized a triphenylamine-ketone donor-acceptor (D-A) type poly(aryl amine-ketone) with multiple redox sites, allowing continuously tunable electrochemical states via hierarchical electron transfer. Combining this polymer with two-dimensional conductive MXene, we constructed a biomimetic nanofluidic transistor. Through side-group tuning to optimize redox matching, the polymer undergoes reversible conformation switching via intramolecular charge transfer at voltages below 1 V. The field-driven conformational changes induce electrostatic attraction, promoting reversible contraction of MXene interlayers. Synergistic coupling of interlayer spacing variation and dynamic interfacial charge rearrangement enables precise hierarchical control of ion flux. The device achieves three switchable ion transport states—closed, partially open, and fully open—with an ion switching ratio of 10 and outstanding cycling stability. Furthermore, synaptic plasticity features emulate fundamental attributes of biological signaling, providing a foundation for bioinspired neuromorphic devices.
Chinese Journal of Environmental Engineering•2026•DOI: 10.12030/j.cjee.202510034
Phosphonate wastewater, characterized by stable C–P bonds, poses significant environmental risks due to its resistance to degradation and potential to contribute to eutrophication. This study developed a chloride-enhanced Fe(II)/PMS/H2O2 system for the oxidative degradation of 2-phosphonobutane-1,2,4-tricarboxylic acid (PBTC) and simultaneous recovery of phosphorus as iron phosphate (FePO4). Under optimal conditions (0.1 mmol/L PBTC, 1.0 mmol/L Fe(II), 0.5 mmol/L PMS, 0.5 mmol/L H2O2, 10 mmol/L NaCl, initial pH 3.0, 60 min), total phosphorus (TP) removal reached 100%, with phosphorus nearly completely recovered as FePO4 precipitate. Increasing NaCl concentration and temperature enhanced TP removal, while pH significantly influenced removal efficiency and product speciation; acidic conditions (pH < 4.3) favored FePO4 precipitation. Coexisting Ca2+ and Mg2+ had negligible effects, whereas HCO3− and humic acid (HA) inhibited TP removal in a concentration-dependent manner. Radical quenching and electron spin resonance (ESR) analyses identified hydroxyl radicals (•OH), ferryl ion (Fe(IV)=O), sulfate radicals (SO4•−), and chlorine radicals (Cl•) as primary reactive species, with •OH playing a dominant role. Chloride introduction promoted the generation of multiple reactive species, and Cl• and its derivative Cl2•− directly attacked the C–P bond and phosphonate group, facilitating phosphorus release as PO43− and subsequent FePO4 formation. The system's feasibility was validated using actual industrial circulating cooling water. This study provides a novel approach for phosphonate wastewater treatment and phosphorus recovery.
SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-025-3984-5
Rechargeable aluminum batteries (RABs) are promising for large-scale energy storage due to high theoretical capacity, inherent safety, and abundant aluminum reserves. However, conventional AlCl3-based ionic liquid electrolytes suffer from high cost, uncontrolled dendrite growth, and severe anode corrosion. Here, a molecular-level ligand engineering strategy is proposed, employing nitrogen-containing cyclic amides with tunable N–H functionalities to modulate the coordination environment of deep eutectic electrolytes (DEEs). Combined experimental and theoretical investigations reveal that the α-pyrrolidone-based DEE (PDEE) possesses a wider electrochemical window, higher ionic conductivity, and lower polarization. Precise N–H regulation optimizes cationic ligand and chloroaluminate anion interactions, accelerating ion transport to facilitate uniform Al deposition without dendrites. The amine functionalities enable in situ construction of a uniform inorganic-organic bilayer solid electrolyte interphase, mitigating anode corrosion and enhancing long-term interfacial stability. As a result, Al//Al symmetric batteries with PDEE achieve stable cycling for over 2000 hours, while Al-graphite full batteries demonstrate negligible capacity decay after 6000 cycles. This study establishes that ligand molecular engineering offers an effective strategy for optimizing DEEs, enabling durable and high-performance RABs.
SCIENCE CHINA Materials•2025•DOI: 10.1007/s40843-025-3631-1
Anion exchange membrane water electrolysis (AEMWE) offers cost and dynamic-response advantages over proton exchange membrane systems, yet commercial deployment is constrained by the alkaline stability of anion exchange membranes (AEMs) and the sluggish kinetics of non-precious metal catalysts. This work reports a series of poly(terphenyl-diphenylmethane piperidinium) (QPDPMTP) membranes synthesized with varied diphenylmethane (DPM) content. The alkyl chain of DPM induces pronounced microphase separation and elevates free volume fraction, yielding an OH− conductivity of 152 mS cm−1 at 80 °C for QPDPMTP-10. After 1032 h immersion in 6 M NaOH at 80 °C, the membrane retains 90.7% of its initial conductivity. An AEMWE cell integrating QPDPMTP-10 with a non-precious NiFeCo LDH/NiS/NF anode achieves 3.11 A cm−2 at 2 V in 1 M KOH at 80 °C and sustains 1 A cm−2 for 1800 h under gradient KOH concentration. These results establish a viable pathway for durable, low-cost AEMWE systems.