SinoGreenTech Academic Portal
LC
Verified CAS / Academic Author2 Decoded Studies

Prof. LI Chunyu

School of Electronic Information Engineering, Inner Mongolia University, Hohhot 010021, China

Research Publications & English Decoded Briefs

Showing 2 publications
Acta Energiae Solaris Sinica2026DOI: 10.19912/j.0254-0096.tynxb.202608_9710

Collaborative Optimal Scheduling of Microgrids Incorporating Electric Heavy-Duty Truck Battery Swap Stations

The integration of electric heavy-duty truck battery swap stations (BSSs) into microgrids introduces a bidirectional coupling between renewable generation volatility and swap demand that existing dispatch frameworks fail to capture. This study formulates a tri-layer collaborative optimal scheduling model spanning the microgrid, the battery swap station, and the heavy-duty truck fleet. The microgrid layer maximizes daily revenue by co-optimizing microgas turbine, battery storage, wind, and photovoltaic outputs, with CPLEX resolving the mixed-integer linear program. The BSS layer adjusts service fees to influence truck arrival rates, thereby reshaping the station load profile to track renewable generation. The truck layer responds to fee signals by autonomously selecting swap times, with a 15-minute discretization interval. An antelope optimization algorithm solves the BSS-truck subproblem, and the two layers iterate until convergence. The framework is validated against a case study, demonstrating that fee-mediated demand response reduces curtailment and improves supply-demand balance. The model addresses a critical gap: prior BSS scheduling treated arrival rates as exogenous and ignored renewable fluctuations, while truck swap decisions ignored station service capacity. By internalizing both signals, the proposed architecture achieves coordinated optimization without centralized control over vehicle behavior.

Chinese Journal of Environmental Engineering2026DOI: 10.12030/j.cjee.202508052

Numerical Simulation of the Performance of a Channel-Steel Baffle-Type Pre-Dust Collector for Biomass Boiler Flue Gas

To improve the performance of pre-dust collectors in biomass boiler flue gas purification systems, a novel channel-steel baffle-type pre-dust collector was proposed to address the low collection efficiency of conventional designs. A gas-solid two-phase flow model was developed within the MP-PIC (multiphase particle-in-cell) framework and validated against physical experiments. The model simulated gas-particle motion inside the collector, systematically investigating the effects of structural modifications, flue gas conditions, and dust properties on collection efficiency and pressure drop. Results indicate that adding a flow baffle in the ash hopper and adopting an upper-inlet flue duct enhance collection efficiency with negligible impact on pressure drop. Flue gas velocity significantly influences performance: increasing velocity reduces efficiency while raising pressure drop; an optimal design velocity of 1.0–2.0 m·s−1 is recommended. Elevated flue gas temperature slightly decreases both efficiency and pressure drop, with minimal impact over a range of tens of degrees Celsius. Higher dust density and larger particle size improve collection efficiency and reduce pressure drop, whereas higher dust concentration increases both efficiency and pressure drop. The study elucidates the mechanisms by which structural and operational parameters affect pre-dust collector performance, providing theoretical guidance for designing low-resistance, high-efficiency collectors for biomass boilers.