Chinese Journal of Environmental Engineering•2026•DOI: 10.12030/j.cjee.202507057
This study presents a novel electrochemical sensor for the rapid detection of trace lead ions (Pb(II)) in water, utilizing a rod-shaped bismuth-based electrode. The electrode was fabricated by modifying a glassy carbon electrode (GCE) with basic bismuth nitrate [Bi6O5(OH)3](NO3)5·3H2O, synthesized via a chemical precipitation method. The sensor was characterized by X-ray diffraction (XRD), Fourier-transform infrared spectroscopy (FTIR), electron probe microanalysis (EPMA), and energy-dispersive X-ray spectroscopy (EDS), confirming the rod-like morphology and composition. Electrochemical detection was performed using differential pulse voltammetry (DPV) in a 0.1 mol·L−1 NaAc-HAc buffer (pH 4.3). The sensor exhibited a linear detection range for Pb(II) from 1 to 90 μg·L−1, with a detection limit of 0.34 μg·L−1 and a sensitivity of 106 μA·(μmol·L−1)−1. The electrode demonstrated excellent anti-interference capability and reproducibility. Recovery tests in real water samples (tap water and campus lake water) yielded high recovery rates, indicating practical applicability. This work provides a simple, cost-effective, and reliable method for monitoring trace Pb(II) in environmental water, particularly relevant for public swimming pools and similar aquatic facilities.
SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-025-4098-8
Fluorescence image-guided photodynamic therapy (PDT) enables real-time monitoring of photosensitizer biodistribution and metabolism for optimized treatment timing. However, its application remains limited by reliance on high-end imaging systems. To address this, we designed three novel small-molecule photosensitizers (TTNb, TTAn, TTPh) based on a 2-vinylbenzoic acid scaffold, functionalized at the 5-position with nitro, amino, or hydrogen groups. Replacing the nitro group with amino or hydrogen switched aggregation behavior from aggregation-induced emission (AIE) to aggregation-caused quenching (ACQ), accompanied by a red-to-green fluorescence shift and subcellular relocation from liposomes to lysosomes. These findings establish design principles for ratiometric nitroreductase probes and enable systematic comparison between AIE and ACQ photosensitizers. Among these, TTAn exhibited superior cellular uptake (2800 times higher than Ce6 in Eca-109 cells), specific lysosomal targeting, balanced reactive oxygen species (singlet oxygen/superoxide anion) generation, and intense fluorescence. Under white light irradiation, TTAn achieved an IC50 of 21 nM, surpassing Ce6 by 50-fold. Notably, TTAn produced strong fluorescence in mice tumors under both one- and two-photon excitation, detectable using conventional imaging tools (smartphones, DSLR cameras) or even visible to the naked eye, confirming outstanding tumor specificity. Leveraging these advantages, TTAn enabled successful image-guided two-photon PDT in Eca-109 tumor-bearing mice with a single treatment, demonstrating potent therapeutic efficacy and biosafety. This work provides a strategic blueprint for developing small-molecule theranostic agents that operate without complex fluorescence imaging systems.
SCIENCE CHINA Materials•2025•DOI: 10.1007/s40843-025-3396-4
This study addresses the intermittent nature of solar energy by developing a dual-mode energy storage material. A bulky azobenzene derivative, 4’-aminoazobenzene-4-sulfonic acid (AABS), was grafted onto the surface of ZIF-90, yielding ZIF-90-AABS (ZIF-AABS). The surface template effect enables reversible cis-trans isomerization of AABS, achieving photochemical energy storage of 5.1 J g−1. Because AABS is confined to the surface, ZIF-AABS retains the crystalline porous structure of ZIF-90, allowing encapsulation of octadecyl alcohol (OD) as a phase change material (PCM). The resulting composite, OD/ZIF-AABS, exhibits a latent heat storage capacity of 121.3 J g−1 at maximum OD loading, with no significant degradation after 50 melting/solidifying cycles. This work demonstrates a synergistic approach that combines photochemical and phase-change energy storage within a single MOF-based platform, expanding the application scope of azobenzene and MOF composites for solar energy storage.