SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-026-4309-8
Iridium-doped cobalt oxide nanosheets derived from a ZIF template were evaluated as oxygen evolution reaction (OER) catalysts for proton exchange membrane water electrolysis (PEMWE). Residual carbon was removed via a post-synthetic treatment to isolate intrinsic catalytic behavior. The Ir0.23Co0.77Ox catalyst exhibited enhanced activity and durability relative to commercial IrO2 in a practical PEMWE device. Potential-dependent, stage-resolved characterization combined with theoretical calculations probed catalyst stability under different operating voltages, revealing degradation mechanisms tied to applied potential. Contact angle measurements showed that the Ir0.23Co0.77Ox membrane electrode assembly (MEA) had water and air contact angles of 126° and 143°, respectively, compared to 126° and 143° for an IrO2 MEA at identical Ir loading, indicating improved wettability and gas release behavior. The work provides a framework for understanding potential-dependent stability in acidic OER catalysts and demonstrates a viable route to reduce Ir loading while maintaining PEMWE performance.
SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-025-3630-2
This study demonstrates a dual-interface engineering approach for performance enhancement in perovskite-silicon tandem solar cells. By applying ethylenediamine dihydroiodide (EDAI2) to simultaneously modify both top and bottom interfaces of wide-bandgap perovskite layers, we achieve synergistic defect suppression and charge transport optimization. Time-resolved photoluminescence characterization reveals extended carrier lifetimes and improved spatial homogeneity in dual-modified perovskite films. The optimized single-junction wide-bandgap (>1.66 eV) perovskite solar cells attain a champion efficiency of 22.75% with enhanced operational stability. Implemented in perovskite-silicon tandem configuration, the devices achieve over 31% power conversion efficiency, validating the effectiveness of organic ligand-mediated dual-interface engineering in regulating carrier dynamics and advancing perovskite-based tandem photovoltaics.
SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-025-3697-8
Multi-site coupling is a promising strategy for developing highly efficient and CO-resistant hydrogen oxidation reaction (HOR) catalysts for proton exchange membrane fuel cells (PEMFCs). However, designing multifunctional synergistic schemes for single-atom sites remains a significant challenge. Herein, we propose a dual-template-confined oxophilic engineering strategy to construct well-dispersed iridium-nickel (IrNi) atomic dimers adjacent to IrNi nanoclusters on porous nitrogen-doped carbon (IrNi Dimer/NC1.8-PNC). The paired IrNi dimer features an asymmetric Ir-N3 configuration coordinated with heteroatomic Ni-N3O via an N-bridge. Remarkably, IrNi Dimer/NC1.8-PNC exhibits a ~23-fold enhancement in mass activity (4.36 A mg−1 Ir at 20 mV) and 5-fold longer stability compared to benchmarking Pt/C toward HOR, while achieving a high rated power density of 1.18 W cm−2 in PEMFC anode applications. Furthermore, IrNi Dimer/NC1.8-PNC demonstrates superior CO tolerance over monometallic Ir and Pt/C in both half-cell and full-cell devices. Combined experimental and density functional theory studies reveal that oxophilic Ni modulates the electronic environment of Ir through alloying and dimer interactions, thereby enhancing HOR activity. Importantly, the asymmetric IrNi dimer enables efficient CO* and OH* co-adsorption while facilitating CO2* desorption, synergistically mitigating CO poisoning and improving atom utilization efficiency. This work provides a design strategy and fundamental insights for multi-site synergistic catalysts in PEMFC anodes.
Journal of Environmental Engineering Technology•2026•DOI: 10.13205/j.hjgc.202606011
Hexavalent chromium (Cr(VI)) contamination in chromite ore processing residue (COPR) and associated soils poses a persistent environmental challenge. This study developed a dispersedly stabilized iron-sulfur-based slurry (DSS-ISB) modified with an inorganic dispersant to enhance nanoparticle suspension stability and interfacial reactivity. The slurry, with a particle size of approximately 200 nm, efficiently reduced and immobilized Cr(VI) without pH adjustment. Under optimal conditions (liquid-to-solid ratio of 5 mL:10 g, DSS-ISB dosage of 1.8 mg/g, reaction time of 20 h), the removal efficiency exceeded 97%, reducing the leaching concentration from 15.03 mg/L to 0.03 mg/L, well below the GB 5085.3—2007 limit of 5 mg/L. X-ray photoelectron spectroscopy (XPS) and Brunauer-Emmett-Teller (BET) analyses revealed a synergistic mechanism of chemical reduction (Fe2+/S2- as dual electron donors) and surface adsorption, converting toxic Cr(VI) to stable Cr(III). Compared with traditional reductants ferrous sulfate (FeSO4) and sodium sulfide (Na2S), DSS-ISB increased removal efficiency by 28.24% and 6.23%, respectively, and unit mass removal capacity by 92.43% and 77.08%. The reagent cost per ton of COPR was reduced to RMB 36.40, achieving savings of 33.82% and 26.02% versus FeSO4 (RMB 55.00) and Na2S (RMB 49.20). The process eliminates pH adjustment and subsequent passivation, simplifying remediation. DSS-ISB offers an economical and green solution for Cr(VI) remediation in both industrial residues and contaminated soils.
Journal of Environmental Engineering Technology•2026•DOI: 10.13205/j.hjgc.202606018
Swine wastewater, a high-strength organic effluent, offers a viable substrate for anaerobic biohydrogen production, aligning with clean energy recovery. This study compared hydrogen production in three anaerobic sequencing batch reactors (ASBRs) treating: raw wastewater (R1), supernatant after MAP (magnesium ammonium phosphate) precipitation for nitrogen and phosphorus recovery (R2), and the same supernatant with anaerobic sludge heat-treated at 75°C for 0.5 h (R3). Without pH adjustment, hydrogen production in R1 remained below 0.50 mmol/(kg·d). At an influent COD of 1800 mg/L, R2 and R3 achieved hydrogen production rates of 48.17 and 71.44 mmol/(kg·d), respectively. At COD 2400 mg/L, methane concentrations in R1, R2, and R3 were 10.8%, 14.2%, and 9.1%, respectively, indicating MAP pretreatment enhanced both hydrogen and methane production. As COD increased, R1's methane concentration rose to 14.6%, while average COD removal efficiencies for R1, R2, and R3 were 78.9%, 70.8%, and 52.5%, respectively. Under pH adjustment, all reactors peaked at pH 4.0, with hydrogen production rates of 0.10, 7.74, and 8.83 mol/(kg·d) for R1, R2, and R3, respectively. These findings demonstrate that MAP pretreatment combined with sludge heat treatment significantly enhances biohydrogen production, offering a promising strategy for swine wastewater valorization.
Environmental Chemistry•2026•DOI: 10.7524/j.issn.0254-6108.2025041804
Ethylene diamine tetra (methylene phosphonic acid) sodium (EDTMPS), an organic phosphonate scale and corrosion inhibitor, is widely used in industrial recirculating cooling water systems. Its efficient degradation in blowdown water is critical for water reuse. This study employed a plate-frame electrochemical advanced oxidation (EAOP) system with a boron-doped diamond (BDD) anode to degrade EDTMPS. The effects of operating conditions (temperature, voltage, liquid flow rate) and water quality parameters (pH, electrolyte concentration, chloride ion concentration) were systematically investigated. Optimal degradation efficiency of 99.48% was achieved at 50 °C, 300 mL·min−1, 7.0 V, pH 10, and 0.05 mol·L−1 Na2SO4. Electron paramagnetic resonance (EPR) characterization of chloride-containing systems indicated that reactive species included hydroxyl radicals, sulfate radicals, and possibly chlorine radicals. In a coexisting system with benzotriazole (BTA), EAOPs degraded EDTMPS and BTA with comparable efficiencies. The results demonstrate that BDD-based EAOPs is effective for removing organic phosphonates from low-chloride, low-hardness cooling water, offering a promising approach for blowdown water treatment and reuse.
SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-025-4081-y
The evolution of precision medicine has propelled multimodal imaging-guided phototheranostics to the forefront for precise tumor diagnosis and therapy. Low-temperature photothermal therapy (PTT) offers a promising approach for the treatment of melanoma due to its non-invasiveness and minimal damage to normal tissues. However, its efficacy is limited by cancer cell thermal tolerance. To address this, a new type of multifunctional energy disruptor (CAMeO-Q NPs) is developed featuring homologous targeting and mitochondria targeting, and synergistically enhancing low-temperature PTT in melanoma by reversing heat shock protein 90 (Hsp90)-mediated thermal tolerance and blocking mitochondrial adenosine triphosphate (ATP) biosynthesis. The multifunctional energy disruptor enables precise trimodal imaging (fluorescence imaging/FLI, photoacoustic imaging/PAI, and photothermal imaging/PTI) guidance for low-temperature PTT. Comprising a mitochondria-targeting photothermal agent and an Hsp90 inhibitor, CAMeO-Q NPs induce selective mitochondrial damage under 660 nm laser irradiation and downregulate cellular HSP expression by ATP inhibition and Hsp90 inhibitor. This multifunctional energy disruptor provides a novel strategy for enhancing multimodal imaging-guided low-temperature photothermal therapy through combined homologous targeting, mitochondria-targeting, and Hsp90 inhibition.
SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-026-4048-x
Selective oxidation of aromatic alkanes is a key reaction to produce high-value chemicals in the chemical industry. However, the strong C–H bonds and inert chemical properties of aromatic alkanes render the oxidation process difficult, thereby making the development of promising and sustainable catalysts highly desirable. Herein, a resin-assisted coordination co-assembly strategy is developed to synthesize heterometal-doped mesoporous Co3O4 with abundant oxygen vacancies, enabling precise control over both composition and pore structure. The site-specific Mn doping at octahedral sites of mesoporous Co3O4 promotes the formation of oxygen vacancy with enhanced activity. Density functional theory calculations further demonstrate that Mn doping in mesoporous Co3O4 reduces the oxygen vacancy formation energy, induces the electronic structure modifications and introduces the defect energy levels, finally promoting the efficient catalytic oxidation of a series of aromatic alkanes. Representatively, Mn-doped mesoporous Co3O4 exhibits remarkably outstanding catalytic activity, achieving 37% conversion of ethylbenzene and 97% selectivity for acetophenone under solvent-free conditions.