SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-026-4309-8
Iridium-doped cobalt oxide nanosheets derived from a ZIF template were evaluated as oxygen evolution reaction (OER) catalysts for proton exchange membrane water electrolysis (PEMWE). Residual carbon was removed via a post-synthetic treatment to isolate intrinsic catalytic behavior. The Ir0.23Co0.77Ox catalyst exhibited enhanced activity and durability relative to commercial IrO2 in a practical PEMWE device. Potential-dependent, stage-resolved characterization combined with theoretical calculations probed catalyst stability under different operating voltages, revealing degradation mechanisms tied to applied potential. Contact angle measurements showed that the Ir0.23Co0.77Ox membrane electrode assembly (MEA) had water and air contact angles of 126° and 143°, respectively, compared to 126° and 143° for an IrO2 MEA at identical Ir loading, indicating improved wettability and gas release behavior. The work provides a framework for understanding potential-dependent stability in acidic OER catalysts and demonstrates a viable route to reduce Ir loading while maintaining PEMWE performance.
Journal of Environmental Engineering Technology•2026•DOI: 10.13205/j.hjgc.202604028
Accurate accounting of county-level carbon budgets and their spatio-temporal evolution is essential for formulating low-carbon development strategies tailored to each division and achieving carbon peak and neutrality goals. This study constructed a comprehensive, accurate, and unified model to measure terrestrial ecosystem carbon absorption, anthropogenic carbon emissions, and net carbon budget from 2010 to 2020 across the Xinjiang Production and Construction Corps and its divisions. Results indicate: (1) Terrestrial ecosystems consistently acted as net carbon sinks, but total carbon absorption declined slowly, with carbon sequestration capacity persistently decreasing. Cultivated land, the sole carbon source, expanded rapidly into forests and grasslands. Anthropogenic carbon emissions rose steadily, with growth rates sharply decelerating after 2015, exhibiting a spatial pattern of "high in the north and east, low in the south and west." (2) Total carbon emissions/absorptions increased rapidly from 2010 to 2015, then slowed from 2015 to 2020. Energy consumption dominated, contributing over 95% of emissions in each division and 99% regionally. High-emission zones expanded eastward from the 8th Division in the Junggar Basin; by 2020, the 8th, 13th, and 6th Divisions, occupying 26.52% of the land area, carried 78.16% of net carbon emissions, marking them as high-density emission zones. (3) Carbon balance zoning in 2020 identified one carbon sink functional zone, nine low-carbon maintenance zones, and three high-carbon optimization zones, the latter concentrated in a strip in the central-eastern region covering 26.52% of the area.
SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-025-3914-7
Incorporating fluorinated side-chains into M-series acceptors enhances the fill factor (FF) and power conversion efficiency (PCE) of organic solar cells (OSCs). However, the impact of fluorinated side-chain positions on charge mobility and photovoltaic performance remains unexplored. Here, we synthesize a partially fluorinated alkyl chain, 7-butyl-1,1,1,2,2-pentafluoro-octyl, and attach it to either the oxygen or nitrogen atoms of the M-series acceptor backbone, yielding two new acceptors, O5F and N5F. Compared to O5F, N5F exhibits closer π-π stacking and higher charge mobility. Consequently, PM6:N5F-based devices achieve a PCE of 18.8% with an FF of 80.7%, surpassing PM6:O5F counterparts (PCE 17.8%, FF 79.2%). The 18.8% PCE is among the highest reported for A-D-A-type small-molecule acceptors. Notably, PM6:N5F devices show significantly improved operational stability, with a T80 lifetime of 1084 hours under one-sun illumination, versus 123 hours for PM6:O5F. This work demonstrates that positioning partially fluorinated side-chains on nitrogen atoms optimizes intermolecular packing and carrier transport, enhancing both efficiency and stability. It underscores the potential of partially fluorinated side-chains in designing high-performance NFAs.
SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-025-3995-6
The deployment of single-site metal catalytic nodes into zirconium-based metal-organic frameworks (Zr-MOFs) offers vast advantages in catalytic recyclability, product separation, and mechanistic analysis, underscoring their paramount significance in heterogeneous catalysis. Nonetheless, their occupation within pores/channels usually diminishes mass transfer and catalytic efficiency during reactions such as the hydroboration of carbonyl compounds, especially for bulkier substrates. To address this issue, three microporous single-site Ti(IV) embedded Zr-MOFs with sequentially extended ligand arms are novelly synthesized to enable precise pore modulation ranging from 9.04, 10.12, to 11.18 Å. The catalytic performance is investigated using eight carbonyl compounds of varying sizes and four additional larger-scale substrates, which demonstrates that the catalytic efficiency is increased through pore size regulation, yet still away from optimal catalytic performance. Then a further strategy was shifted to the linker installation of linear dicarboxylate ligands chelated single-site Ti(IV) within coordination-unsaturated windows of mesoporous Zr-MOFs, and the result elucidates that the obtained catalyst exhibits superior catalytic efficiency (all exceeding 90%) while preserving the inherent mesoporosity of Zr-MOFs with a pore size of approximately 21.73 Å. We believe this research provides critical guidance for future research on structural design and catalytic optimization of MOFs, opening new avenues in heterogeneous catalysis.