Prof. SUN Xiaotong | Publications & Academic Profile | SinoGreenTech

Research Publications & English Decoded Briefs

Showing 2 publications

SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-026-4415-3

Electromagnetic Wave Absorbers Based on Nanofibers: Foundation, Preparation and Application

The escalating demands of military stealth platforms and the proliferation of electromagnetic pollution have intensified the need for high-performance electromagnetic wave (EMW) absorbers. Nanofibers, characterized by high specific surface area and favorable composite compatibility, are engineered into absorbers with outstanding electromagnetic properties. This review consolidates the preparation and optimization strategies for nanofiber-based absorbers. The electromagnetic attenuation mechanisms are first outlined, followed by a systematic classification of nanofiber fabrication methods into two principal categories: in-situ synthesis and electrospinning-derived processes. Recent advances in optimization strategies for absorbers constructed from nanofibers with tailored electromagnetic characteristics are then examined. The review draws upon representative studies, including ultrathin and flexible electromagnetic interference shielding films via interface-confinement, design strategies for wave-absorbing polymer-based shielding materials, impedance-matchable 3D MXene sponge/NiFe@NC heterostructures with tunable pores, and the influence of fiber coating on SiCf/epoxy composites. These works collectively demonstrate the critical role of fiber architecture, interface engineering, and impedance matching in determining absorption performance. The analysis identifies persistent challenges in scalability, cost, and environmental stability, and outlines future prospects for nanofiber-based EMW absorbers. This review provides a foundational reference for researchers and engineers seeking to translate nanofiber absorber concepts into deployable stealth and pollution-mitigation technologies.

Read Full Analysis→Download Authentic PDF

SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-025-3838-5

Surface-Confined Metallization of Nanofibrous Networks via Selective Dissolution-Assisted Transfer Printing for Lightweight and Air-Permeable Soft Electronics

Air-permeable and ultrathin conductive electrodes are essential for next-generation soft electronics, including breathable wearables, on-skin devices, and bio-integrated electronics. However, conventional metallization strategies, such as sputtering and ink-printing, often suffer from severe vertical charge leakage due to the porous and ultrathin characteristics of nanofibrous networks, leading to device short-circuiting, operational failure, and limited vertical integration. Here, we present a solvent-selective dissolution-assisted transfer printing strategy to achieve surface-confined metallization of ultrathin, lightweight, and gas-permeable nanofibrous networks, enabling lateral conductivity while maintaining vertical insulation. This transfer printing process facilitates not only the rapid formation of conductive patterns on the surface of nanofibrous networks but also mechanical reinforcement through solvent evaporation-induced interlocked fiber-fiber welding. Meanwhile, the strategy preserves the high permeability of the nanofibrous networks and imparts a unique combination of surface conductivity (2 Ω cm) and vertical insulativity (10^11 Ω cm). The resulting anisotropic conductive networks enable low-voltage wearable heaters, high-sensitive pressure sensors, and ultralight temperature sensors. A pressure-temperature dual-modal sensing patch is further fabricated for intelligent grasping classification. The proposed surface-confined metallization strategy enables rapid fabrication of an anisotropic conductive network as a building block to construct air-permeable, ultrathin, and lightweight wearable electronics.

Read Full Analysis→Download Authentic PDF