SinoGreenTech Academic Portal
LH
Verified CAS / Academic Author2 Decoded Studies

Prof. LI Hongxiang

Soochow University

Co-Affiliations:Beijing Normal University

Research Publications & English Decoded Briefs

Showing 2 publications
SCIENCE CHINA Materials2026DOI: 10.1007/s40843-026-4269-4

Nanoparticle-Reinforced Self-Assembled Molecular Interfaces Enable Mechanically Robust Flexible Organic Solar Cells

Self-assembled molecular interlayers (SAMs) are promising hole-selective contacts for high-efficiency organic solar cells (OSCs) due to their well-defined energy alignment and minimal parasitic absorption. However, their intrinsically limited mechanical robustness often leads to structural degradation and performance loss under mechanical deformation, restricting their application in flexible devices. Here, we report a nanoparticle-reinforced self-assembled composite interface that simultaneously enhances mechanical reliability and optoelectronic performance. Uniformly dispersed SiO2 nanoparticles are introduced as high-modulus reinforcing building blocks without disturbing molecular self-assembly. In contrast to NiOx nanoparticles, which suffer from aggregation and parasitic absorption, SiO2 nanoparticles exhibit excellent dispersion and optical transparency, enabling formation of a structurally compatible hybrid interface. Mechanistic studies reveal that SiO2 nanoparticles redistribute interfacial stress and form dynamic hydrogen-bond networks with phosphonic acid groups of 2PACz, providing efficient energy dissipation during cyclic deformation. Meanwhile, modulation of interfacial polarity extends the crystallization time window of the active layer, resulting in enhanced molecular ordering and improved charge transport. As a result, devices based on the SiO2/2PACz composite interface achieve a power conversion efficiency of 20.14% for rigid devices and 19.30% for flexible devices, placing the flexible devices among the highest-performing flexible OSCs reported to date, while retaining over 90% of their initial efficiency after repeated bending cycles. This work establishes a general strategy for overcoming the trade-off between electronic selectivity and mechanical robustness in ultrathin self-assembled molecular interfaces, providing design insights for high-performance flexible organic optoelectronics.

SCIENCE CHINA Materials2026DOI: 10.1007/s40843-025-3793-9

High-efficiency hybrid planar/bulk heterojunction organic solar cells

Organic solar cells (OSCs) require both a high donor/acceptor (D/A) interfacial area for efficient exciton dissociation and a vertically phase-separated morphology for efficient charge transport. Traditional bulk heterojunctions (BHJs) provide large interfacial areas but lack vertical phase separation, while quasi-planar heterojunctions (QPHJs) achieve vertical separation at the cost of reduced interfacial contact. Here, we introduce an in situ pore-forming strategy for polymer thin films. By incorporating an excess of additives as pore-forming agents into the donor layer, a nanoporous film with a fibrous nano-network is generated. Subsequent deposition of acceptor molecules fills these nanopores, creating a hybrid planar/bulk heterojunction (HP/BHJ) that synergizes the strengths of both architectures. This design enhances performance by: (1) increasing the D/A interfacial area via nanopores, forming a three-dimensional network that accelerates exciton dissociation; (2) promoting close molecular packing that minimizes carrier recombination and establishes low-defect charge transport channels; and (3) fostering vertical phase separation through layer-by-layer deposition. Binary OSCs fabricated with this strategy achieve a power conversion efficiency (PCE) of 20.0%, surpassing conventional BHJ and QPHJ devices by a significant margin. The approach demonstrates general applicability, with analogous improvements observed in D18/BTP-eC9-4F and PM6/L8-BO systems, underscoring its potential for advancing OSC performance.