SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-026-4480-1
Ternary organic solar cells (OSCs) incorporating a structurally compatible guest acceptor (C7-Cl) into the PM6:BTP-eC9 host system are demonstrated. The low Flory-Huggins interaction parameter between host and guest acceptors facilitates intimate mixing, optimizing molecular packing and energy-level alignment. High-sensitivity sEQE and EQEEL analyses reveal a reduced non-radiative energy loss (KE3) of 0.216 eV in the ternary device. Consequently, the optimized ternary OSC achieves a champion power conversion efficiency (PCE) of 20.02% and an improved T80 operational lifetime of 1065 h. This work establishes a feasible strategy via structurally compatible guest doping to simultaneously optimize vertical phase separation and suppress non-radiative loss, providing a facile and effective route toward high-performance and stable OSCs.
SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-026-4290-9
Thermoelectric materials enable direct and reversible conversion between heat and electricity, offering unique advantages for waste heat recovery, solid-state refrigeration, and deep-space power systems. The performance is evaluated by the dimensionless figure of merit, zT = S²σT/κ, where S is the Seebeck coefficient, σ is the electrical conductivity, T is the absolute temperature, and κ is the total thermal conductivity. Achieving high zT requires simultaneous realization of a large power factor (S²σ) and low thermal conductivity. However, these parameters are intrinsically coupled, posing a fundamental challenge. PbTe is a representative thermoelectric material operating in the intermediate temperature range, with outstanding performance originating from its unique electronic band structure featuring multiple nearly degenerate valence band maxima near the L points. Band convergence via alloying with mono-tellurides such as MgTe, MnTe, CdTe, YbTe, SrTe, and EuTe effectively modifies the valence band structure, increasing band degeneracy and density-of-states effective mass, thereby enhancing electrical conductivity without decreasing the Seebeck coefficient. However, increasing the content of these mono-tellurides limits acceptor dopability, making conventional dopants like Na difficult to incorporate. This study demonstrates that co-doping strategies can preserve dopability while achieving band convergence and dislocation engineering, leading to significantly reduced lattice thermal conductivity and extraordinary peak zT values. The decoupling of electronic and thermal transport through this approach offers a promising route for high-performance thermoelectrics.
SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-025-3642-4
High-density glass scintillators are promising alternatives to crystals for next-generation radiation detection due to their low cost, excellent physical and chemical stability, and processability. In this study, a series of Ce3+-activated gadolinium gallium borosilicate (GGBS x) glasses were synthesized via vacuum melt-quenching. With increasing Gd2O3 content, glass density increased from 5.86 to 6.05 g/cm3, and molar volume from 36.43 to 39.79 cm3/mol. Extended X-ray absorption fine structure (EXAFS) analysis revealed that in GGBS 1 glass, Ce3+ exclusively adopts a hexahedral [CeO6] configuration, while Gd3+ exhibits both hexahedral and octahedral coordination with a bond length of 2.35±0.1 Å and Debye-Waller factor σ2 of 0.0122±0.0015 Å2. As Gd2O3 content increased, shallow trap depth rose from 0.804 to 0.858 eV, while deep trap depth first increased from 0.948 to 1.434 eV then decreased to 1.010 eV. GGBS 1 glass exhibited high transmittance (~80%) in the visible range and a photoluminescence quantum yield of 78.4%. Under X-ray irradiation, its X-ray excited luminescence intensity reached 128.5% of that of Bi4Ge3O12 (BGO) crystal, with a spatial resolution of 29.1 lp/mm, approaching the highest reported for glass scintillators. Under γ-ray excitation, it achieved a light yield of 1058 photons/MeV and an energy resolution of 23.7% at 662 keV. These results indicate that GGBS 1 glass scintillator warrants further development for applications in X-ray imaging and γ-ray spectroscopy.
Journal of Environmental Engineering Technology•2026•DOI: 10.13205/j.hjgc.202605019
The utilization of food waste as a fermentation substrate can effectively reduce the substrate cost of lactic acid production industrialization, and synergistic fermentation with leachate could promote lactic acid production. However, the effect of magnesium ions in leachate on lactic acid production, metabolic processes, and key functional bacterial communities remains unclear. This study investigated the effect of adding magnesium ions on lactic acid fermentation using food waste as substrate. Results showed that the optimal magnesium ion dosage was 750 mg/L, achieving a lactic acid yield of (37.4±0.5) g COD/L and L-lactic acid optical activity of (96.3±0.9)%. Mechanistic studies revealed that magnesium ions accelerated substrate dissolution, significantly enhanced the activities of key hydrolytic enzymes (α-glucosidase, amylase, protease) and L-lactic acid producing enzymes, thereby increasing hydrolysis and lactate production rates. Simultaneously, the relative activity of lactate-consuming enzymes decreased, slowing lactate consumption. At 750 mg/L Mg2+, the relative abundances of Enterococcus and Streptococcus were 65.0% (2.2 times the Blank) and 18.7% (37.8% of the Blank), respectively, with a total of 83.7%, enhancing lactic acid yield and L-lactic acid optical activity. Metabolic pathway prediction and functional gene analysis further indicated that magnesium ions increased the relative abundance of carbohydrate metabolism pathways and genes encoding lactate dehydrogenase. This study provides technical support for food waste resource utilization.
Environmental Chemistry•2026•DOI: 10.7524/j.issn.0254-6108.2025030602
In the context of accelerated urbanization, regional air composite pollution in medium and large urban agglomerations is primarily characterized by PM2.5-O3 compound pollution. To elucidate the meteorological causes of PM2.5-O3 compound pollution in the Yangtze River Delta (YRD) region over the recent seven years (2017–2023), this study analyzed monitoring data from typical cities (Nanjing, Shanghai, Hangzhou, and Hefei) using Pearson and partial correlation coefficients. Results indicate: (1) PM2.5 pollution exhibited a significant downward trend across all four cities, with notable improvement during the COVID-19 pandemic in 2020, underscoring the effectiveness of air pollution control measures. Conversely, O3 pollution remained elevated or increased in some cities, indicating persistent challenges in O3 control. (2) During O3 pollution episodes, PM2.5 and O3 concentrations were positively correlated, whereas during PM2.5 pollution episodes, they were negatively correlated. (3) Compound pollution days were predominantly observed from February to October, with the highest frequency (20 days) occurring from April to June. (4) The significant reduction in PM2.5 weakened the aerosol 'umbrella effect', enhancing surface radiation and promoting near-surface O3 formation. Concurrently, changes in the NOx/VOCs ratio weakened O3 titration, and climate warming accelerated O3 precursor generation and potentially altered boundary layer structure, collectively contributing to O3 accumulation in the cold season and an increasing frequency of compound pollution during that period. (5) The formation mechanisms of PM2.5 and O3 are driven by distinct meteorological conditions, with low overall concentration correlation; however, under compound meteorological conditions such as high temperature, stagnant air, and weak diffusion, both pollutants tend to rise synchronously, indicating that compound pollution events are typically driven by multiple adverse meteorological factors. This study demonstrates that from 2017 to 2023, PM2.5 pollution significantly decreased while O3 pollution showed an increasing trend. Compound pollution was concentrated in April–June and influenced by high temperature, stagnant air, and weak diffusion. With effective PM2.5 control, enhanced surface radiation and changes in O3 precursors led to O3 accumulation in the cold season, increasing compound pollution frequency. Overall, compound pollution is driven by multiple meteorological factors, posing complex challenges for control.
SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-025-3990-6
Sustainable bio-sourced functional materials are pivotal for advancing wastewater treatment technologies. This study reports a lignin-based carbon nanofiber (CNF) scaffold engineered with a Bi2WO6 (BWO) and ZnIn2S4 (ZIS) Z-scheme heterojunction via coaxial electrospinning and hydrothermal synthesis. The resulting all-component photocatalytic nanomembrane exhibits superior mechanical robustness under wet conditions, with a Young's modulus of 20.38 MPa and toughness of 2.48 kJ/m3. Stabilization kinetics are accelerated 10-fold (1°C/min), yielding significant energy savings. Using methylene blue (MB) as a model pollutant, the CNFs@BWO/ZIS membrane achieves 94.4% degradation efficiency (k = 0.01664 min−1) after 120 min of solar irradiation, maintaining excellent recyclability over five successive cycles. Systematic mechanistic studies elucidate the Z-scheme charge-transfer pathway, which optimizes interfacial photoexcited carrier separation and reduces energy loss. This work demonstrates a sustainable biomass-derived photocatalytic system with high mechanical integrity and catalytic performance, offering a viable route for efficient wastewater treatment and contributing to carbon neutrality goals.
Environmental Chemistry•2026•DOI: 10.7524/j.issn.0254-6108.2025051701
This study investigated the effects of selenium nanoparticles (SeNPs) on the growth, mycelium morphology, copper (Cu2+) removal rate, extracellular polymeric substances (EPS), and intracellular enzyme activity of Aspergillus flavus TL-F3 (A. flavus TL-F3) under Cu2+ stress. Results showed that different concentrations of Cu2+ inhibited the growth of A. flavus TL-F3. The highest Cu2+ removal rate of 56.32% was observed at a Cu2+ concentration of 50 mg·L−1. Under 50 mg·L−1 Cu2+ stress, 0.25 mg·L−1 SeNPs promoted the growth of A. flavus TL-F3, increasing its biomass by 2.71%, and significantly enhanced the fluorescence intensity of EPS, Na+/K+-ATPase activity, and decreased malondialdehyde (MDA) content, reduced superoxide dismutase (SOD) and catalase (CAT) enzyme activities. Additionally, SeNPs stimulated the glutathione (GSH-GSSG) cycle in A. flavus TL-F3, elevating glutathione peroxidase (GPX) and glutathione reductase (GR) activity by 17.2% and 23.94%, respectively, and increasing reduced glutathione (GSH) content by 18.59%, and decreasing the GSH/GSSG ratio, thereby effectively alleviating Cu2+ toxicity. Fourier transform infrared spectroscopy indicated that surface functional groups of A. flavus TL-F3, including carboxylic acid, alcohol, phenol, and phosphate/sulfate functional groups, might bind with Cu2+, enhancing its tolerance to Cu2+. This study enriches the theoretical knowledge of microorganism-heavy metal interactions and provides deeper insights into microbial heavy metal resistance mechanisms.