SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-026-4236-8
Electrochemical nitrate reduction (NO3RR) to ammonia offers a sustainable route for nitrogen recovery from wastewater, yet its efficiency is constrained by complex multi-step proton-electron transfers and competitive hydrogen evolution. Here, we report a series of binary cobalt-copper phosphates with precisely tuned Co/Cu ratios, revealing a volcano-type relationship between composition and catalytic activity. The optimized Co0.5Cu1.5(OH)PO4 catalyst, supported on a Ni3Co1OxHy/Ni foam substrate, achieves a Faradaic efficiency of 99.0% for ammonia at a high current density of 200 mA cm−2 in 1 M nitrate electrolyte, with a production rate of 9.18 mg h−1 cm−2 and sustained stability over 200 hours. In-situ ATR-FTIR spectroscopy and density functional theory calculations elucidate a tandem mechanism: Co sites promote water dissociation to generate active hydrogen (H*), while adjacent Cu sites facilitate nitrate adsorption and subsequent hydrogenation steps. This synergistic division of labor lowers the energy barrier for the rate-determining step, effectively suppressing HER and enhancing intrinsic kinetics. The work demonstrates that precise atomic-ratio engineering in dual-site transition metal phosphates provides a viable strategy to overcome activity-selectivity trade-offs in electrocatalytic nitrate-to-ammonia conversion.
SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-025-3652-2
Existing robotic end-effector gripping technologies often encounter challenges such as poor adaptability to environmental changes, incomplete deformation sensing, and insufficient adhesion stability, which can compromise operational safety and reliability. Here, we present the bio-inspired self-sensing suction cup, in which the core self-sensing capability is achieved by combining high-performance, laser-induced graphene/Ag NWs flexible sensors with a Wheatstone bridge design. The flexible sensors provide high sensitivity, while the Wheatstone bridge circuit enables accurate and stable detection of deformation during the gripping process. Integrated into the octopus-inspired suction cup, this system allows for real-time monitoring of deformation and adsorption stability. The self-sensing suction cup demonstrates good performance across a 0–25 kPa negative pressure range, with outstanding linearity (R2 = 0.993) and high sensitivity (GF = 10.436 kPa−1). Experimental results confirm that the suction cup can achieve stable adsorption under varying loads and enable real-time monitoring of the suction cup status during the gripping process. This design provides a promising solution for intelligent gripping systems, logistics, and object recognition in challenging environments.
Journal of Environmental Engineering Technology•2026•DOI: 10.13205/j.hjgc.202604024
To enhance sludge dewatering efficiency, an MnFe2O4/BC/PMS system was constructed for sludge disintegration. Single-factor and multi-factor experiments were conducted to investigate the effects of MnFe2O4/BC (MFB) dosage, PMS dosage, and reaction time on sludge dewatering performance, establishing the optimal process parameters and the primary-secondary relationships among environmental factors. Active species identification in the MnFe2O4/BC/PMS system revealed the main free radicals responsible for sludge disintegration and the primary pathways of EPS breakdown. Results showed that the influence order of environmental factors on sludge moisture content (Wc) and total organic carbon (TOC) was MFB > PMS > reaction time, while the interaction effects followed MFB-PMS > PMS-reaction time > MFB-reaction time. Optimal dewatering occurred at MFB dosage of 132.99 mg/g DS, PMS dosage of 421.80 mg/g DS, and 18 min reaction time, achieving Wc of 45.8% and TOC of 489.2 mg/L. The ·OH and SO4−· radicals released from MnFe2O4/BC-activated PMS oxidized protein main chains, causing peptide chain breakage. This primarily reduced protein content in sludge from 174.6 mg/L to 75.7 mg/L, with TB-EPS protein content decreasing from 91.8 mg/L to 36.3 mg/L, thereby reducing EPS hydrophilicity and improving sludge dewatering efficiency.
Journal of Fuel Chemistry and Technology•2026•DOI: 10.1016/S1872-5813(25)60629-3
This study reports the synthesis of a novel Z-scheme heterojunction composite film comprising Ag/Bi2MoO6/BiOBr via electrochemical processes, ion-exchange techniques, and subsequent photodeposition of silver nanoparticles. The incorporation of Ag nanoparticles exploits localized surface plasmon resonance (LSPR) effects and serves as an electron mediator, establishing a Schottky barrier that suppresses charge recombination. The optimized 1.5% Ag/Bi2MoO6/BiOBr film achieves a CO production rate of 13.65 μmol/(g·h) from photocatalytic CO2 reduction, significantly outperforming the unmodified Bi2MoO6/BiOBr film. Photocurrent and impedance analyses confirm enhanced charge separation in the Ag-modified composite. A non-linear relationship between Ag loading and photocatalytic efficiency was observed, with optimal performance at 1.5% Ag. The proposed Z-scheme mechanism elucidates the synergistic interactions among components, providing a scientific basis for rational design of advanced photocatalysts and immobilized systems for CO2 reduction. This work offers insights into the development of efficient, sustainable photocatalytic technologies for carbon capture and utilization.
Environmental Chemistry•2026•DOI: 10.7524/j.issn.0254-6108.2025021902
Polyacrylonitrile (PAN) ultrafiltration membranes are widely used in water treatment, yet their anti-fouling performance remains a challenge. In this work, PAN was first reacted with sodium azide via click chemistry to synthesize 1,2,3,4-tetrazolium polyacrylonitrile (PAN-N). Subsequently, PAN-N was reacted with iodoacetamide (IAM), 2-iodoethanol (IH), iodoacetic acid (IA), and chlorosulfonic acid (CSA) to introduce hydrophilic groups, and anti-fouling PAN ultrafiltration membranes were fabricated via phase inversion. The membranes were characterized by Fourier transform infrared spectroscopy, 1H nuclear magnetic resonance, X-ray diffraction, scanning electron microscopy, and contact angle measurements. Results showed that the PAN-N membrane exhibited superior performance to pristine PAN, with water flux increasing from 0.9233 to 1.232 L·(m2·h·kPa)−1 and bovine serum albumin (BSA) rejection from 69.23% to 82.4%. Hydrophilic modification further enhanced performance; the PAN-N-IA membrane achieved the highest water flux of 1.7347 L·(m2·h·kPa)−1 and rejection of 93.57%. Anti-fouling tests revealed that modified membranes followed the order: PAN-N-CSA > PAN-N-IA > PAN-N-IH > PAN-N-IAM > PAN-N > PAN. PAN-N-CSA and PAN-N-IA showed comparable anti-fouling performance, with total fouling indices of 56.1% and 58.47%, reversible fouling indices of 47.17% and 46.97%, and irreversible fouling indices of 8.97% and 11.47%, respectively. This work demonstrates that PAN-N-IA membranes combine high flux, high rejection, and excellent anti-fouling properties, making them promising for water treatment applications.
Environmental Chemistry•2026•DOI: 10.7524/j.issn.0254-6108.2025021903
Volatile organic compounds (VOCs) are key precursors of secondary organic aerosols (SOA), and their oxidation reactions are regulated by reactive intermediates. A deep understanding of the reaction mechanisms of VOCs-derived reactive intermediates is crucial for evaluating SOA formation. Atmospheric peroxyalkyl radicals (RO2·) are important intermediates produced during VOCs oxidation and can generate highly oxygenated organic molecules (HOMs) through a unique atmospheric autoxidation mechanism, contributing significantly to SOA formation. This article reviews recent advances in computational studies on the autoxidation mechanisms of RO2· with different functional groups, focusing on the autoxidation reactions of RO2· derived from alkanes, alkenes, carbonyl compounds, aromatic hydrocarbons, heteroatom-containing compounds, and other substances. The review highlights the commonalities and differences in autoxidation mechanisms across these functional groups, emphasizing the role of intramolecular hydrogen shifts and subsequent O2 addition steps. Furthermore, we emphasize that future research should focus on the autoxidation of second-generation RO2· and autoxidation mechanisms driven by different intramolecular reactions. Quantum chemical calculations, often combined with kinetic modeling, provide molecular-level insights into reaction pathways and rate constants, which are essential for predicting HOM formation and SOA yields. This review aims to guide further theoretical investigations and support the development of more accurate atmospheric chemistry models.