SinoGreenTech Academic Portal
ZH
Verified CAS / Academic Author2 Decoded Studies

Prof. ZHANG Hongliang

College of Environment Science and Engineering, Tongji University

Co-Affiliations:Department of Environmental Science & Engineering, Fudan University

Research Publications & English Decoded Briefs

Showing 2 publications
Journal of Environmental Engineering Technology2026DOI: 10.13205/j.hjgc.202607009

Current Status of Food Waste Anaerobic Digestion and Challenges in Carbon Source Production in China

Resource utilization of food waste is a key measure for implementing waste classification and constructing zero-waste cities in China. However, the technical route based on anaerobic digestion currently faces developmental bottlenecks. In this study, engineering-scale facilities located in Northeast, North, Northwest, and Southeast China were selected, and material flow analysis was employed to comprehensively assess the current status of anaerobic digestion of food waste. The results indicated that, during the pretreatment stage, both leachate and organic slurry from all surveyed regions exhibited high COD/TN ratios, and the leachate contained high concentrations of lipids. Following three-phase (oil-water-solid) separation, the oil recovery rate could reach over 98%. Anaerobic digestion of each ton of food waste from the four regions generated approximately 70 to 80 Nm³ of biogas, while simultaneously producing liquid digestate accounting for 69% to 80% of the total mass and solid digestate accounting for 2.7% to 3.6%. However, the annual continuous production of digestate was not aligned with the seasonal demand for land use, thereby restricting the pathway for resource utilization. Converting food waste into an external carbon source can significantly enhance its resource utilization efficiency, with the economic benefits increasing by more than 203% compared to the methanogenesis pathway. The selection of the carbon source production technology route should be comprehensively determined by taking into account factors such as the specific nitrogen removal requirements of the target wastewater treatment process, the quality requirements for the carbon source products, and the substitution rate of commercial carbon sources.

Environmental Chemistry2026DOI: 10.7524/j.issn.0254-6108.2025041505

Characteristics and Causes of PM2.5 Changes in the Fenwei Plain from 2013 to 2020

To combat severe air pollution, China has implemented a series of air pollution control action plans since 2013, effectively alleviating PM2.5 pollution. However, PM2.5 concentrations in most cities within the Fenwei Plain still exceed national standards. This study systematically evaluates PM2.5 concentration changes across two policy phases (2013–2020) using the Community Multiscale Air Quality (CMAQ) model, quantifying contributions of meteorology and emissions, and analyzing sectoral source changes. Results show that annual average PM2.5 concentration declined cumulatively by 19% during 2013–2020. In the first phase (2013–2017), regional PM2.5 decreased by 3% annually, with most improvement in winter; however, due to unfavorable meteorology, concentrations increased in Xi'an and Xianyang. In the second phase (2017–2020), PM2.5 declined by an additional 16%, with more effective control measures, particularly in spring and autumn. Emission reductions dominated in both phases, with stronger effects in the second phase (−8 μg·m−3), significantly outweighing adverse meteorological contributions (+3.5 μg·m−3). Nevertheless, many cities still face challenges from unfavorable meteorology, highlighting the need for future policies to account for meteorological influences. Emissions from industrial, energy, and agricultural sources decreased significantly across both phases. However, during winter heating periods, residential emissions emerged as a source equal in importance to industrial emissions, becoming a key target for future emission controls.