SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-025-3625-3
Zirconia (ZrO2)-based fluorite ferroelectric materials are promising for nonvolatile memory and logic devices due to their CMOS compatibility and cost advantages over hafnium oxide (HfO2). However, the metastable nature of the ferroelectric orthorhombic phase (o-phase) hinders practical application. Here, we report the strain-mediated stabilization of the ferroelectric o-phase in ZrO2 thin films grown on niobium-doped strontium titanate (NSTO) substrates with different crystallographic orientations via chemical solution deposition. Systematic structural and ferroelectric characterization, combined with simulation, reveals that substrate orientation controls in-plane tensile strain, selectively promoting epitaxial growth of the o-phase. The ZrO2 film on NSTO(110) exhibits the highest o-phase content, achieving a remanent polarization (2Pr) of 92.64 μC/cm², which remains as high as 88.54 μC/cm² after resistive-capacitive (RC) delay calibration. The device shows endurance of approximately 10^7 cycles with favorable fatigue characteristics. X-ray absorption spectroscopy (XAS) further indicates distortion of Zr-O tetrahedra, providing microscopic insight into the ferroelectricity. This work presents a novel strategy for property tuning of ZrO2 films and supports their application in storage and logic devices.
SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-025-3807-8
Electrocatalytic co-reduction of CO2 and nitrate offers a sustainable route for urea synthesis, valorizing nitrogenous waste and CO2. However, achieving high-performance urea electrosynthesis under ambient conditions remains challenging due to the need for simultaneous activation of CO2 and efficient H2O dissociation to supply active *H for *NOx hydrogenation, ultimately forming key C- and N-containing intermediates for C–N coupling. Here, we report a bifunctional Pd-single-atom-modified Cu (Pd1Cu) nanorod catalyst that synergistically promotes adsorption and stepwise activation of CO2 and H2O, steering the reaction pathway toward selective urea synthesis. Integrating experimental evidence, in situ spectroscopy, and computational analyses, we disclose that atomically dispersed Pd sites kinetically favor co-generation of *CO and *NH2 via H2O dissociation-driven proton transfer, forming an optimal intermediate balance. The dual metal active sites enhance C–N coupling via combined electronic and geometric effects, substantially lowering the reaction energy barrier and improving selectivity. This work provides a rational design strategy for advanced multifunctional catalysts for urea electrosynthesis, contributing to carbon neutrality and waste nitrogen valorization.
SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-025-3485-0
Aqueous Zn-ion batteries (AZIBs) are promising for next-generation energy storage due to high safety and low cost, but their practical use is limited by Zn dendrite growth and side reactions. An ideal anode/electrolyte interphase should block water contact while enabling fast Zn2+ transport, yet conventional thick interphases increase ionic resistance and polarization. Here, we report a hydrophobic yet ultrathin (~5 nm) polydimethylsiloxane (PDMS) artificial interphase fabricated via conformal coating. The oxygen-rich PDMS layer selectively coordinates Zn2+ while its superhydrophobicity excludes water, and the ultrathin nature enables rapid Zn2+ conduction, enhancing the Zn2+ transference number by 2.28-fold. This synergistic design suppresses dendrites and mitigates hydrogen evolution. The PDMS-modified anode achieves 99.9% Coulombic efficiency over 3500 cycles, 880-hour symmetrical cell operation at 60% depth of discharge, and 2500-cycle full-cell endurance under lean Zn conditions (N/P ratio 5.7). Proof-of-concept pouch cells sustain 1400 cycles with a 0.01% decay rate. This molecular-scale interphase strategy provides a feasible pathway toward practical AZIB implementation.
SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-026-4208-8
Sodium-ion batteries (SIBs) are emerging as a cost-effective alternative to lithium-ion batteries due to the abundance of sodium resources. Among cathode materials, P2-type layered oxides (Na_xTMO_2) offer high ionic conductivity and rate capability but suffer from low initial sodium content and Na+/vacancy ordering, leading to structural degradation and capacity fading. This study proposes a synergistic strategy combining high sodium content with Li/Mg co-doping to enhance the cycling stability of P2-type cathodes. The high sodium content increases the sodium reservoir, reducing the depth of desodiation for a given capacity, while Li/Mg co-doping mitigates Na+/vacancy ordering and stabilizes the crystal structure. The optimized cathode exhibits significantly improved cycling performance, retaining 82.3% of its initial capacity after 500 cycles at 1C, compared to 65.4% for the undoped counterpart. Furthermore, the co-doped material demonstrates enhanced rate capability, delivering 112 mAh/g at 5C, and suppressed phase transitions, as evidenced by in-situ X-ray diffraction. This work provides a rational design pathway for high-performance P2-type cathodes, addressing key bottlenecks in SIB commercialization.