SinoGreenTech Academic Portal
JD
Verified CAS / Academic Author2 Decoded Studies

Prof. Jiao Dong

The Key Laboratory of Weak-Light Nonlinear Photonics, Ministry of Education, School of Physics, Nankai University

Research Publications & English Decoded Briefs

Showing 2 publications
Journal of Environmental Engineering Technology2026DOI: 10.13205/j.hjgc.202604022

Synergistic Benefits of Pollution Reduction and Carbon Mitigation from Converting Food Waste into Carbon Sources for Wastewater Treatment Plants

The resource utilization of food waste contributes to reducing environmental pollution, driving nutrient cycling and biomass energy development, and promoting the resource recycling industry, achieving a win-win outcome for environment and economy. This study evaluated the resource recovery performance and environmental impacts of producing carbon sources for wastewater treatment through hydrolysis and acidification of food waste, comparing with two conventional alternatives: anaerobic fermentation and incineration. Results showed that among the three technologies, hydrolysis for carbon source production ranked middle in resource recycling efficiency, but its environmental benefits were superior to incineration and anaerobic fermentation. The hydrolysis process did not produce additional wastewater requiring treatment, and its greenhouse gas emissions and solid waste generation intensity were relatively low, at -40.7 kg CO2-eq/t and 9.3%, respectively. Carbon sources derived from food waste can replace commercial alternatives, reducing wastewater treatment costs and promoting synergies between pollution reduction and carbon mitigation. Sensitivity analysis revealed that water content in food waste significantly influences solid impurity generation and energy recovery efficiency of hydrolysis technology. In regions with high food waste generation and carbon source demand, hydrolysis technology is recommended to facilitate large-scale synergistic treatment of wastewater and food waste.

SCIENCE CHINA Materials2026DOI: 10.1007/s40843-026-4149-1

Giant Optical Anisotropy in the Edge Surfaces of Layered Crystals: Unveiled by Direct Measurements of Out-of-Plane Optical Constants

Large optical anisotropy is paramount for efficient light manipulation in optoelectronic devices. Van der Waals layered materials, exhibiting large structural contrast between in-plane and out-of-plane directions, are inherently anisotropic in 3D space. However, measurements of their optical constants have been limited to 2D planes. Here, we directly measure reflectance spectra from the edge and basal surfaces of layered MoS2, NbOCl2, and WTe2 crystals to compare out-of-plane and in-plane optical constants in the 500–1000 nm range. Results show that out-of-plane refractive indices are smaller than in-plane values. Out-of-plane extinction coefficients are zero for MoS2 and NbOCl2 but nonzero for WTe2, confirmed by transient reflection spectroscopy. The nonzero extinction in WTe2 arises from symmetry of transition dipole moments and density of states dictated by crystal structure. Out-of-plane optical constants of MoS2 and NbOCl2 exhibit less dispersion than in-plane, whereas WTe2 shows enhanced out-of-plane dispersion around 2.14 eV, attributed to increased optical transition probability from larger density of states. These parameters indicate giant birefringence (>1.8 for MoS2, >0.6 for NbOCl2, >0.5 for WTe2) and linear dichroism (up to 100% for MoS2 and NbOCl2, 40.7% for WTe2) on edge surfaces. Results enable prediction of optical response at arbitrary incidence angles, aiding polarization-related optoelectronic devices.