SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-025-3700-7
Photocatalytic synthesis has been considered a promising technology for solar-to-chemicals conversion. Here, a series of novel photocatalysts was synthesized by decorating uranyl sites on imine-based covalent organic frameworks (i-COF) and proved functioning for the uniformly boosted H2O2 production by 1.6–10.1 folds compared with the bare i-COFs in a wide pH range from 2 to 11. Typically, an optimal H2O2 production rate of 1435.9 μmol g−1 h−1, i.e., 28.72 mmol g(U)−1 h−1, was realized over uranyl decorated TTa-COFs under visible light. Systematic investigations reveal that the universally and remarkably promoted performance is attributed to the outstanding electron-transfer ability, accelerated activation of molecular oxygen and favored formation of ·O2− and *OOH as the key intermediate by virtue of the decorated uranyl ions; thus the two-step single-electron oxygen reduction reaction (ORR) for H2O2 photo-generation is significantly facilitated. This work paves a new way for the uranyl-decorated COFs as a novel photocatalyst and provides in-depth insight to the reaction mechanism for photocatalytic H2O2 production.
SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-025-3744-9
The high-value utilization of industrial wastes is critically important for environmental protection and sustainable development. In this work, amorphous NaFeP2O7 (NFPO) and NaFeP2O7/rGO (NFPO/rGO) composite are synthesized via a selective chemical precipitation approach, utilizing industrial jarosite residue as the iron source. The sodium storage performance and mechanism of this amorphous NFPO/rGO composite as a novel cathode material for sodium-ion batteries (SIBs) are explored for the first time. The as-synthesized amorphous NFPO/rGO composite exhibits outstanding long-term cycling performance of 79.1 mAh g−1 after 1000 cycles at 0.1 A g−1, while the crystalline NFPO/rGO composite does not work. Galvanostatic intermittent titration technique and in-situ electrochemical impedance spectroscopy analysis demonstrate that the amorphous NFPO/rGO composite has high Na+ diffusivity and fast kinetics. In-situ X-ray diffraction analysis reveals the structure change from amorphous NaFeP2O7 to triclinic Na2FeP2O7 during the first discharge process and then evolves to a highly disordered structure in the subsequent charge/discharge cycles. The present work not only provides an avenue for the high-value utilization of jarosite residue but also offers theoretical guidance for the structural design and development of NaFeP2O7-based cathode materials for SIBs.
SCIENCE CHINA Materials•2026•DOI: 10.1007/s40843-025-3464-4
Photocatalytic conversion of atmospheric CO2 (0.03%) into multi-carbon fuels remains a grand challenge due to the high energy barrier of C–C coupling and the low concentration of CO2. Here, we report the construction of multiple metal pair sites on metal oxide nanosheets to steer C–C coupling, enabling efficient photoreduction of air-concentration CO2 to ethane (C2H6). As a prototype, Au nanoparticles were anchored on Bi4Ti3O12 nanosheets (Au-Bi4Ti3O12). High-resolution transmission electron microscopy and X-ray photoelectron spectroscopy confirmed the formation of Au-Ti metal pair sites at the interface. In situ Fourier transform infrared spectroscopy revealed the presence of *OCCOH intermediate on Au-Bi4Ti3O12 during CO2 photoreduction, which was absent on pristine Bi4Ti3O12. Density functional theory calculations showed that the Gibbs free energy for *CO–COH formation on Au-Bi4Ti3O12 is 2.23 eV, significantly lower than that on Bi4Ti3O12 (3.59 eV), indicating facilitated C–C coupling. Consequently, Au-Bi4Ti3O12 exhibited a C2H6 evolution rate of 2.58 μmol g−1 h−1 under 0.03% CO2, whereas Bi4Ti3O12 produced only C1 products (CO and CH4). This work demonstrates the first single-catalyst photoreduction of atmospheric CO2 to C2H6, highlighting the effectiveness of engineered multiple active sites in overcoming the C–C coupling bottleneck.
SCIENCE CHINA Materials•2025•DOI: 10.1007/s40843-025-3576-6
Emulating biological synaptic plasticity is essential for advancing artificial intelligence. However, in most existing synaptic phototransistors to date, both electrical and optical stimuli induce weight modulation within a comparable dynamic range, limiting plasticity tunability and richness. Here, we report a synaptic phototransistor that enables distinct weight modulation in response to electrical and optical inputs, achieving hierarchical, multi-scale plasticity with concurrent visible-light emission for direct display. The device integrates a long-afterglow material that converts transient ultraviolet (UV) excitation into persistent visible emission, serving as a temporally extended, memory-like optical stimulus. Compared to direct electrical gating, this delayed optical activation of the optoelectronic channel induces weight modulation on a significantly longer timescale, enabling hierarchical plasticity and cascade interactions between optical and electrical pathways. The dual-output architecture allows simultaneous optical visualization and electrical signal processing, effectively integrating optical perception with in-sensor computation. Leveraging this design, we demonstrate a UV-resolvable neural network capable of direct image display and achieving a recognition accuracy of 95.03% for handwritten digits. This work establishes a new paradigm for multimodal neuromorphic systems by seamlessly integrating sensing, display, and computation within a unified in-sensor architecture.